- Get more attention and visibility from the vehicle behind you in traffic.
- 16 flashing modes that no one else has.
- Much brighter and cooler than a normal taillight.
- 12 LEDs for stop/ tail lamp.
- IP66 dust & waterproof compliant*.
- Indicator function. (Need to install two lamps)
Oi Flash Controller SPEC
♦ 16 different modes that can be applied to your stop light, turn signal light, hazard light, and decoration light.
♦ Operate in the voltage range from 6.5V to 16V. (Suitable for 12V vehicle power system)
♦ Ambient temperature must not below -20° (-4°F) and not exceed +85° (185°F).
♦ Works both for halogen & LED bulbs.
♦ Super-duper easy set up for LED lights. NO LOAD RESISTOR IS NEEDED.
♦ Maximum current rating up to 8A. (Suitable for up to 4 light bulbs with 21W)
Oi Flash Controller is designed to replace a 3-pin flasher relay ONLY (not for a 4 or 5 pin relay, it will destroy the device).
Reflector, Frame: ABS
LED tail light x 1, Oi flash controller x 1
Tail/ stop: red LED
Indicator: amber LED
Tail/ stop: 12pcs red LED, 12V 0.1W/ 12V 1.7W
Indicator: 6pcs amber LED, 12V 2.0W
The turn signal lights are 2.0W instead of 1.2W in mass production.
(Note: The imprint on unit wasn't revised specifically.)
Tail light: 145mm/ 5.7 inch
Oi flash controller: 155mm/ 6.1 inch
Tail lamp, (optional)turn signal
EMI class 3 and IP66 dust & waterproof Compliant*
ECE, SAE approved.
*Protected from dust / Protected against powerful jetting of water.
1. These are NOT plug & play parts, motorcycle electrical knowledge is required.
2. Newer Harley-Davidsons run the "indicator flash rate" through the OEM TSM/TSSM modules. You can not use Oi flash controller if the OEM TSM/TSSM modules include the circuit of your motorcycle.